Boba Fett

The Sure Plug is an essential accessory for use with the Glock® pistol. It is an inexpensive part that serves several important purposes on the firearm.

►Will aide in guiding a magazine into the magazine well which will decrease the time required for those crucial magazine  changes. It will provide the user with the assurance that the magazine will not hang-up on the bottom rear of the magazine well by providing a smooth, rounded surface to guide magazines into place.

►The Flush fit of the plug also eliminates the possibility of snagging on the open cavity.

►The cavity on the backside of the handle (pistol grip), just behind the magazine well, is hollow and open at both the top and bottom. This opening can allow debris such as dust, dirt, sand, snow, lint and water to reach the trigger assembly and firing pin of the Glock® pistol. The addition of this simple and inexpensive hand gun part can eliminate the potential problems created by this debris.
►You do not need to be a Glock
® Certified Armorer to install this part. It simply snaps into place and it stays securely in position.

Sure Plug SP4 for Glock®

DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. or GLOCK Ges.mbH. Neither Molon Labe, nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.mbH. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For genuine GLOCK, Inc. and GLOCK Ges.mbH products and parts visit

Molon Labe® Laser Engraved Firearms Accessories and Apparel
©Copyright 2011-17 All Rights Reserved
Website Development by: Molon Labe, LLC


Proudly made in the USA

DISCLAIMER: Color of each engraving will vary.

Molon Labe® Laser Engraved
Sure Plug SP4 for Glock
® Pistol

The sure plug for Glock® pistols is made from advanced polymer material

Fits Gen 4 Glock® Models: 17, 19, 22, 23, 31, 32, 34, and 35.

Will NOT Fit Model 20, 21, 26, 27, 29, 30, 33, 36, 37, 38, 39, 41, 42, and 43.

Not designed for Gen 1-3 models nor to fit added backstrap installed
All design and work are performed at the Molon Labe
® facility in Arizona. Made in the USA.
Price: $9.95